 |
GSP-810 1GHz Spectrum Analyzer |
* High Resolution of Span to Measure the more detailed signal: Zero, 2kHz ~ 100MHz /DIV
* High Input Protection Level: +30dBm, ±25VDC
* Reference Level Range: -30dBm ~ +20dBm
* Good Noise Floor Performance
* Spurious Noise: < -60dB
* Intermodulation (3rd): < -70dBc
* Two Markers for Absolute and Relative Measurement
* Functions: Max. Hold, Average (2 ~ 32 traces), Freeze, Peak Search, Marker to Center Function
* 9 Memories of Save/Recall
* RS-232 Interface and Display Software to get Trace from GSP-810 to PC
* Options: Power Meter, Tracking Generator, Remote Control Software
| Frequency | |
| Frequency Range | 150kHz ~ 1000MHz |
| Frequency Resolution | 1kHz C.F. entry, 40Hz Sweep resolution at 2kHz/DIV |
| Frequency Display | 6 1/2 digit setting |
| Frequency Control | Digital phase locked |
| Frequency Stability | ±2ppm/year aging,±10ppm, 0 to 50°C |
| Frequency Spans | Zero, 2kHz to 100MHz/DIV, in a 1-2-5 sequence |
| Bandwidth | |
| Resolution Bandwidths | 3kHz, 30kHz, 220kHz, 4MHz |
| Resolution BW Accuracy | 15% |
| Video Bandwidth | 1.6kHz/90kHz coupled with RBW |
| Amplitude | |
| Reference Level Range | -30dBm to +20dBm |
| Reference Level Accuracy | ±1dB at 80MHz |
| Input Level Range | -100dBm to +20dBm |
| Noise Floor | -95dBm@30kHz RBW, -100dBm typical/-75dBm:150kHz ~ 10MHz |
| Amplitude Display Range | 75dB |
| Amplitude Accuracy | ±1.5dB typical@0dBm, 80MHz |
| Amplitude Level Linearity | ±1.5dB over 70dB |
| Ref. Level Freq. Flatness | ±1.5dB over 100MHz, ±2.5dB typical over entire band/±3dB:150kHz ~10MHz |
| Harmonic Spur Response | <-40dBc, RF input < selected reference |
| Non-Harmonic Spur Response | <-60dBc typical down from reference level, average, 5MHz/div |
| Intermodulation(3rd) | <-70dBc, @-40dBm input, 2 tones, 2MHz apart/<-45dBc:150kHz ~10MHz |
| Phase Noise | -77dBc/Hz at 1GHz, 30kHz offset |
| Input | |
| Input Overload Protection | +30dBm continuous, ±25VDC |
| Impedance | 50 ohm nominal |
| Return Loss | <16 dBRL (VSWR < 1.35) |
| Input Attenuation | 50dB to 0dB in 10 dB steps coupled to reference level |
| Connector | Type N female |
| Marker | |
| Number of Markers | 2 |
| Marker Resolution | 0.1dB, 1kHz |
| Marker Mode | Absolute, Relative, PK -> Marker, Marker -> Center |
| Marker Accuracy | 0.1dB±amplitude accuracy |
| Functions | |
| Memory | 9 memories of save/recall |
| Trace | Max. Hold, Average(2 ~ 32 traces), Freeze(Hold) |
| Setup | Access parameters |
| FM/AM Demodulator | |
| WB FM | 120kHz deviation |
| MB FM | 75kHz deviation |
| NB FM | 30kHz deviation |
| AM Outputs | Internal speaker, 3.5mm stereo jack, wired for mono operation |
| Remote Display Software & RS-232 | |
| Connecting to PC and getting trace from GSP-810, software will be downloaded from here | |
| General | |
| Power Source | 100/120/220/230V AC±10%, 50/60Hz |
| Accessory | Instruction Manual |
| Dimensions | 12.20"W X 5.91"H X 17.91"D |
| Weight | 18.74 lbs |
| Options and Prices | |
| GSP-810 (Spectrum Analyzer) $2139.95 | |
| GSP-810TG (w/ Tracking Generator) $2999.95 | |
| Frequency Range | 10MHz to 1000MHz |
| Amplitude Range | 0 to -50dBm |
| Amplitude Resolution | 1dB |
| Amplitude Accuracy | ±1dB@ 80MHz, 0dBm |
| Attenuation Accuracy | ±1dB@, 50MHz |
| Amplitude Flatness | ±1dB@, 10MHz/DIV, ±1.5dB@0dB,entire band |
| Harmonics | <-30dBc |
| Reverse Power | <+30dBm |
| Impedance | 50 ohm nominal |
| Return Loss | <10 dBRL (VSWR<2) |
| Connector | Type N female |
| GSP-810PM (w/ Power Meter) $2699.95 | |
| Frequency Range | 10MHz to 2GHz, usable to 2.7GHz |
| Power Level Range | -20dBm to +23dBm, usable to +30dBm |
| Power Level Overload | +40dBm<10% duty cycle, <10mS duration |
| Return Loss | <1:1.35 VSWR into 50 ohms, <1:1.25 typical |
| Readout Resolution | 0.2mW, 100mW scale, 2µW, 1mW scale; 0.1dB, Log scale |
| Accuracy | ±(10% rdg ±1digit) |
| Readout | mW or dBm |
| GSP-810TGPM (w/ Tracking Generator and Power Meter) $3299.95 | |
| Remote Control Software Add $189.95 | |
| Connecting PC to get trace and provide the control for setting | |