5 MHz Sweep Function Generator / Counter
$329.95
| Waveform | Sine, square, triangle, ramp, TTL pulse |
| Operating Mode | Sweep, AM, gated burst, VCG |
| Amplitude | Continuously variable to 20Vpp (adjustable range 20dB) (10 Vpp into 50Ω load) |
| Fixed Attenuator | -10dB, -20dB, -20dB 3 steps |
| Output Impedance | 50Ω± 10% |
| DC Offset | ± 10V max.(± 5V into 50Ω load) |
| Symmetry | 1:20 (inverse 20:1) |
| Frequency Setting | Range Selector | 0.5Hz to 5MHz in 7 ranges |
| Tuning Range | Each range provides 100:1 frequency control | |
| Sine wave | Distortion | ≤ 1.0% from 0.5Hz to 100kHz |
| T.H.D. | ≤ 30dB below fundamental in all ranges (Specification apply from MAX. to 1/10 level) | |
| Amplitude | ≤ ±3%(0.3dB) below 500kHz | |
| Flatness | ≤ ±10%(1.0dB) below 5MHz | |
| Square wave | Symmetry | ± 1% from 1Hz to 100kHz |
| Rise/Fall Time | ≤ 40nS at maximum output (into 50Ω load) | |
| Triangle wave | Linearity | ≥ 99% TO 100kHz |
| TTL Pulse | Amplitude | ≥ 3Vpp |
| Rise/Fall Time | ≤ 25ns | |
| Fan Out | 20 TTL loads | |
| Sweep Operation | Mode | LINear/LOGarithm |
| Sweep Width | LIN / LOG: ±10:1 | |
| Sweep Rate | Continuous variable from 2S to 20mS | |
| AM Modulation | Modulation Ratio | 0 to 100% |
| Int. Source | 1kHz sinewave | |
| Carrier -3dB Bandwidth | 100Hz to 5 MHz | |
| Ext. Modulation | DC TO 20 kHz | |
| Ext. Sensitivity | ≤ 6Vpp for 100% modulation | |
| Gated Burst | Burst Source | Internal/External |
| Burst Width | Continuously adjustable from 5% to 90% of period of internal gating frequency (with burst width control) | |
| Repetition Rate | 0.5Hz to 50Hz(int.) DC to 500kHz(ext.) |
|
| External Level | TTL Level (Hi ≥ 2.4V, Lo
≤0.8V) (LO: Burst ON, HI: Burst OFF) |
|
| Burst Frequency | As determined by frequency dial and range switch. Tone burst is in integral half cycle of frequency being gated. Burst may also be swept or modulated | |
| VCG (Voltage Control Generator) | Input Control | 0 to +10V
DC(1000:1) Frequency decreases with positive voltage. Frequency may be programmed with DC voltage. |
| Input Impedance | 10kΩ± 10% | |
| GCV (Generator Control Voltage) | Output | 0 to +2V proportional to dial setting or sweep frequency |
| Frequency Counter | Display | 0.4" LED x 6 digits, Hz, kHz, gate, overflow indicators |
| Mode | Internal/External | |
| Range | Internal 0.5Hz to 5MHz/External 5Hz to 10MHz | |
| Accuracy | Timebase accuracy ± 1count | |
| Resolution | 0.1S, 1S, 10S | |
| Sensitivity | ≤ 20mV RMS | |
| Timebase | ± 10 ppm (25ºC±5°C) after 30 minutes warm up | |
| Input Impedance | 1MΩ / 100pF | |
| General | Input Jacks | VCG In, Counter In, Burst In, AM In |
| Output Jacks | Main Output, GCV Out, Sweep Out, Burst Out | |
| Input Limit | VCG In: 0 to 12 VDC, AM In: 10 Vpp, Burst In: TTL level | |
| Weight | 8.8 lbs. | |
| Dimension | 8.5"W X 4.3"H X 10.9"D |